The gear that goes inside the tent: a light for smaller tents, a clip fan to keep air moving around the plants, and a dehumidifier for damp rooms. VIVOSUN sizes each one to a tent, so start with the size you have.
How to choose by job
Light: LumaLight 200W
The LumaLight 200W is VIVOSUN's full-spectrum panel for 2x4 and 3x3 tents. It runs 672 LEDs mixing 3000K and 5000K white with 660 nm red and 730 nm far-red, a knob dims it in four steps from 25% to 100%, and it's rated IP65 for humid tents. For its LumaLight panels, VIVOSUN suggests hanging about 24–30 in (610–762 mm) above seedlings on a low setting, then lowering the light as plants grow. For a 4x4, the matched light is the LumaLight 400 W in the 4x4 kit.
Circulation: AeroWave A6
An inline fan exchanges the air in a tent; a clip fan stops it sitting still between the leaves. The AeroWave A6 is a 6-inch clip fan with two speeds (1400 and 2200 RPM), 90° automatic oscillation, a 120° manual tilt and a natural breeze mode. VIVOSUN rates it as quiet as 38 dB, and its lever-lock clamp grips round poles, square frames and flat surfaces. It runs on buttons, with no app to set up.
Humidity: AeroDrain D12
The AeroDrain D12 removes up to 12 liters of moisture a day and is recommended for tents up to 5 × 5 ft. It drains through the included hose or switches off when the tank is full, restarts after a power cut, and connects to the VIVOSUN app. VIVOSUN notes that results depend on room temperature, humidity and tent size.
A quick way to decide
- 2x4 or 3x3 tent with no light yet: LumaLight 200W.
- Leaves barely moving: AeroWave A6.
- Humidity climbing when the lights go off: AeroDrain D12.
Check your tent's volume in the grow tent sizes guide, or see how the pieces fit together in the VIVOSUN review.